您要查找的是不是：
- With the acrylic acid(AA) and the glycol(EG) as raw materials,Direct etherification method is usded to synthesize the ethylene glycol diacrylate(EGDA). 以丙烯酸(AA)與乙二醇(EG)為原料,采用直接酯化法合成出了二丙烯酸乙二醇酯(EGDA)。
- The thermal properties of ethylene propylene copolymer g acrylic acid(EPM g AA) and ethylene propylene copolymer g maleic anhydride(EPM g MAH) were investigated by using DSC. 用DSC研究了共聚聚丙烯－g－丙烯酸（EPM－g－AA）和共聚聚丙烯－g－馬來酸酐（EPM－g－MAH）的熱學性質。
- Progressing plasma treatment and grafting acrylic acid(AA) by plasma solicitation were studied. 通過進性等離子體處理及等離子體引發丙烯酸接枝處理丙綸纖維研究。
- A novel solid acid catalyst,H3PW12O40(HPW) supported on HZSM-5, has been prepared for use in the esterification of acrylic acid(AA) with n-butanol. 制備了負載型疏水性固體酸催化劑H3PW12O40/HZSM-5,并將該疏水性固體酸催化劑用于丙烯酸(簡稱AA)與正丁醇的酯化反應中。
- The process of acrylic acid (AA) grafted onto waste polystyrene (PS) in emulsion phase reaction conditions was introduced. 介紹了丙烯酸接枝改性廢聚苯乙烯泡沫塑料制備乳液型涂料的方法。
- Spent sulfite liquor(SSL) from bagasse pulping was modified by graft copolymerization of acrylic acid(AA) and/or acrylamide(AM) onto lignosulfonate. 利用木質素磺酸鹽與丙烯酸(AA)、丙烯酰胺(AM)等單體的接枝共聚反應,直接對亞硫酸鹽制漿廢液(SSL)進行接枝改性。
- One is the same downstream products that can be gotten from ethylene and propylene,such as chloroethylene, vinyl acetate and acrylic acid, etc. 另一類是乙炔專用化學品,如炔醛法化學品(1,4-丁二醇系列)乙炔基醚、聚乙炔等。
- SHANGHAI HUAYI ACRYLIC ACID CO., LTD. 上海華誼丙烯酸有限公司。
- The copolymer of acrylic acid(AA) and acrylic amide(AM) was prepared through solvent polymerization with initiator, and spinned into fibers. 摘要采用溶液合法成了丙烯酸/丙烯酰胺共聚物紡絲液，并紡制成纖維。
- The impregnant emulsion of filter paper is fabricated by the copolymerization of styrene,butyl methacry late(BA)and acrylic acid(AA)etc. 采用乳液聚合方法制備出以苯乙烯、丙烯酸丁酯(BA)為主體,加入其他功能性單體共聚的苯丙乳液。
- Using benzophenone (BP) as photoinitiator, the photografting polymerization of acrylic acid (AA) on PET track membranes was studied. 其改性主要采用輻射和等離子體接枝的方法，本文將表面光接枝技術應用于PET核孔膜的改性和功能化，研究了核孔膜上的光接枝反應和方法，通過表面接枝丙烯酸，膜通量得到顯著的提高，通過接枝不同單體，制備了新型表面孔封蓋結構的環境敏感型分離膜。
- Polyethylene (PE) has been modified by a small amount of mixing ethylene acrylic acid (EAA) copolymer.The water treeing in PE modified was also studied. 以不同含量的乙烯丙烯酸共聚物(EAA)對聚乙烯(PE)進行了共混改性,研究了改性后實驗樣品中水樹的生長情況。
- Amination of(E)-3-(thiophen-2-yl)acrylic acid with thionyl chloride and ammonia gave(E)-3-(thiophen-2-yl)acrylamide in 91% yield. 3-(2-噻吩)丙烯酸與氯化亞砜和氨作用生成3-(2-噻吩)丙烯酰胺,收率91%25;
- The graft copolymerization of acrylic acid (AA) onto low density polyethylene(LDPE) with benzoyle peroxide (BPO) as initiator in anhydrous xylene was studied. 在二甲苯溶液中以過氧化苯甲酰為引發劑研究了丙烯酸在聚乙烯上的接枝共聚。
- Latex particles were obtained by soapless emuls ion copolymerization of styrene (St) and methyl methacrylate (MMA) in the presen ce of functional monomer acrylic acid (AA) . 以苯乙烯、甲基丙烯酸甲酯為主單體，丙烯酸為功能單體合成了三元無皂乳液共聚膠粒。
- Methacrylic acid (MAA) or acrylic acid (AA) can improve properties great in which the former is much better, and get high strength, high elongation with common hardness. 甲基丙烯酸的溶脹效果遠大于丙烯酸,與不加(甲基)丙烯酸的硫化膠相比,改性后力學性能提高很多,即使在普通硬度下也能達到高強度、高伸長率(邵A硬度72左右,拉伸強度約為28Mpa,撕裂強度約為52N/mm,斷裂伸長率約為810%25)的特點。
- Two polymer were synthesized by copolymerization of acrylamide(AM) ,acrylic acid(AA),acrylo-nitrile(AN).They were used as absorbent for fresh water or salt water each. 采用丙烯酰胺(AM)、丙烯酸(AA)、丙烯腈(AN)三元共聚法合成了兩種分別適于淡水和鹽水的吸水膨脹聚合物。
- A series of copolymers containing vinyl isobutyl ether (VIBE),acrylic acid(AA),2 - acrylamido - 2 - methyl propane sulfonic acid(AMPS) have been synthesized. 以乙烯基異丁醚(VIBE)、丙烯酸(AA)、2-丙烯酰胺-2-甲基丙磺酸(AMPS)為單體,合成了單體比例不同的系列聚合物。
- In the typical case of ethylcellulose/ acrylic acid (EC / AA) system, cholesteric (helical) Properties and the influence factors of ethylcellulose liquid crystals were studied. 以乙基纖維素／丙烯酸體系為例，對乙基纖維素液晶的膽甾相性質及其影響因素進行了研究，測定了體系膽甾相結構的螺距。
- The bonding performance of chloroprene rubber (CR)/methyl methyacrylate(MMA) graft adhesive is enhanced by means of adding the second monomer,acrylic acid(AA). 在氯丁橡膠 (CR)和甲基丙烯酸甲酯 (MMA)接枝膠中 ,通過加入第二單體丙烯酸 (AA) ,進一步提高CR/MMA接枝膠的粘接性能。
